Note that Biamp Launch must be initiated to properly configure connected devices.
The TesiraFORTÉ X will automatically discover connected devices and supports the following Biamp peripherals without further configuration:
TCM-1, TCM-1A, TCM-1EX
TCM-X, TCM-XA, TCM XEX
TTM-X, TTM-XEX
EX-UBT, EX-USB
AMP-450P, AMP-450BP
HD-1
The TesiraFORTÉ X will include appropriately connected devices in the layout as part of the Biamp Launch process and will be visible in the device table on the web interface when connected. After Launch, devices will be configured automatically when they are powered up:
Configured
Devices that have been properly configured via Biamp Launch will be indicated by a green checkbox; devices that have not been configured will be indicated by a yellow exclamation mark.
Alarm
Devices that are operating properly with no alarms will be indicated by a green checkbox in the Alarm column. An exclamation mark indicates an issue (fault) in the system. See Troubleshooting for a list of faults in a system
Model
Indicates the model type of device connected. This is not editable by the user.
Description
The description will be populated by default based on the device type (microphone, amplifier, etc.) but is user editable. For example, a user my prefer to name devices by location, room, etc.:
Serial Number
Gives the serial number of the connected device.
Firmware
Gives the currently-installed firmware version.
Locate
Clicking locate will initiate the locate function of the connected device (audio, lights, etc. depending on the device.)
Locate Level
Devices equipped with an audio locate function have the additional option of adjusting the level of the locate audio.